The means to meet the demand for hot water depends on the tank. With the advancements made in energy efficiency, a new hot water heater is often more efficient than an old one. But before you have your new hot water heater installed, you need to prepare to accept the new appliance into your home. This includes checking a few things before the installation happens.
One of the things you should check before the Water Heater Installation in Allentown is the plumbing system. Attaching new pipes to an old system may cause problems especially if the older pipes are not in good condition to begin with. In some cases, you may need to update your plumbing system. Also, you want to make sure piping runs are installed if you plan on adding things like a dishwasher to your kitchen or an extra bathroom.
Another thing you should have checked is the electrical system. While the breaker can probably handle the new system adequately, an older panel may have issues when the system is connected up. Plus, old wiring runs should be replaced before the new system is installed. It is also important to ensure that the wiring used to hook up the hot water heater is the same as the wiring used throughout the entire home. A quick check of this system will ensure that it is ready for the new hot water heater.
If you have a gas system instead of an electric system for your Water Heater Installation in Allentown, you need to make sure your system is ready for the new heater. Have someone check out the gas flow and the shutoff valves for where the new hot water heater will be connected. This is to ensure that it is safe to proceed with the hookups. It is also a good time to get an inspection of your whole system to ensure that it isn’t leaking.
These are some of the things to have checked before your new hot water heater is installed. Sometimes, there are issues when connecting a new appliance into an older system. So, it does pay to have it checked to make certain that your plumbing, wiring and gas can handle this new addition.